Rice-lake DWM-IV Weighmeter Series 9 Setup Manual Instrukcja Użytkownika Pobierz pdf (Strona 23)

Error Messages

Error Messages Explanation

CAP OL Over Capacity, weight value exceeds the full scale capacity

ADC UL Input load cell signal is too low or reversed, load cell or load cell -cable is faulty

ADC OL Input load cell signal is too high, load cell or load cell-cable is faulty

NOT CAL Scale is Not yet Calibrated

RMT DSP

Will be displayed on Remote Display Unit when there is no signal from th e Main

Display

RMT OPE

Will be displayed on Remote Operation Unit when there is no signal from the Main

Display

SPAN OL Maximum calculated span count is greater than m aximum ADC Chip count

LO BAT Insufficient battery voltage level. Need to re-charge the battery

- - - - - - -

Display if Power On Zero fails. Need to unload the scale or optional press Zero

Key if power on zero weight is within allowable zero range

S.TOTAL

Displayed before entering the password if Sub Total printing is pending. Need to

press ‘Shift’+’Print’ to print the Sub Total and ‘Shift’+’G/N’ to print the Grand Total

G.TOTAL

Displayed before entering the password if Grand Total printing is pending. Need to

press ‘Shift’+’G/N’ to print the Grand Total

Jumper Settings

Reference Table For Jumpers

JP-1 Calibration Enable

JP-2 Reserved

JP-3 Not in use

JP-4 Not in use

JP-5 Not in use

JP-6 to set Excitation Voltage to 5V (Use to conserve power d uring battery operation)

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 34 35

Brak uwag

Rice-lake DWM-IV Weighmeter Series 9 Setup Manual Instrukcja Użytkownika Strona 23